CA 95 Aftermarket Custom 6 Volt Turn Signals

[Spokes]

Here are a few examples of the "Spokes" method of building turn signals for your CA95. This method works on CA & CB models 6 or 12Volt.

The external mounted switch (left or right hand)


A close up of a handlebar mounted signal


The front View


If you don't want to run the wires through the frame, you can make the rear fender brace a "conduit" This is a pic of a brace that is wired for signals and power for saddlebag lights.


This is where the "winker" goes


This is a pic of the rear signals mounted. These signals also mount with room for Buco Bag Mounts

[tuff cub]

looks great! i'm so used to using hand signals from not having them on the benly, i've taken to just doing it on all my bikes. you've made a nice solution.

[aaron7]

Using hand signals and working the clutch is NOT easy!

Spokes, shoot me a PM when you get a chance.