CA 95 Aftermarket Custom 6 Volt Turn Signals
Posted: Sat May 15, 2010 9:48 pm
Here are a few examples of the "Spokes" method of building turn signals for your CA95. This method works on CA & CB models 6 or 12Volt.
The external mounted switch (left or right hand)
A close up of a handlebar mounted signal
The front View
If you don't want to run the wires through the frame, you can make the rear fender brace a "conduit" This is a pic of a brace that is wired for signals and power for saddlebag lights.
This is where the "winker" goes
This is a pic of the rear signals mounted. These signals also mount with room for Buco Bag Mounts
The external mounted switch (left or right hand)
A close up of a handlebar mounted signal
The front View
If you don't want to run the wires through the frame, you can make the rear fender brace a "conduit" This is a pic of a brace that is wired for signals and power for saddlebag lights.
This is where the "winker" goes
This is a pic of the rear signals mounted. These signals also mount with room for Buco Bag Mounts