Page 1 of 1
Camshaft gear washer
Posted: Wed Jan 29, 2014 7:56 pm
by VegeKev
Hey Benly People,
A couple of quick questions re the 37.5mm washer (part#90482-200-000) that supposedly goes between the camshaft and cam gear....supposedly because I don't appear to have one
Firstly....do all models have one?
Secondly, can someone tell me the thickness of said washer so I can make one?
Thirdly, is said washer hardened?
Thanks heaps....
Kev.
Posted: Thu Jan 30, 2014 1:16 am
by Sam Green
I'll have a look, should be able to find one.
Sam.
Posted: Thu Jan 30, 2014 1:26 am
by Spokes
I'll check my parts drawer, I may have one as well.
Posted: Thu Jan 30, 2014 1:40 am
by Sam Green
Not got one in the house but will have one in the shed but its behind a load of the guy downstairs stuff to heavy to lift on my own, we share the shed.
If chip don't find one, I'll pull one out of a motor I have outside.
Sam.
Posted: Thu Jan 30, 2014 2:54 am
by Spokes
I'll check the shop later today. I'm pretty sure I have one.
Posted: Thu Jan 30, 2014 3:04 am
by Sam Green
It's sorted Chip, I'm on my way to the post office to ship it.
Sam.
Posted: Thu Jan 30, 2014 3:25 am
by Sam Green
It's on its way to Armidale NSW.
Sam.
Posted: Thu Jan 30, 2014 9:10 am
by Spokes
OK, I had the part as well.....
Posted: Thu Jan 30, 2014 11:18 am
by Sam Green
I've probably got quite a few but they are all in the back of the shed I'm sharing, At least we know where to get the next one. hahaha
Sam.
Posted: Thu Jan 30, 2014 12:25 pm
by VegeKev
Geez....happy days
Woke up wondering if anyone had read my post only to discover its all been sorted
Thanks heaps Sam and Spokes .... Once again I am in your debt!
Kev
Posted: Thu Jan 30, 2014 12:57 pm
by Sam Green
Posted: Thu Jan 30, 2014 1:53 pm
by VegeKev
G'day Sam,
I'm getting used to being in it .... It's just the depth that varies
Many thanks again
Kev
Posted: Thu Jan 30, 2014 5:24 pm
by Sam Green
Posted: Fri Jan 31, 2014 9:40 pm
by VegeKev
Just as a double check that I'm not going in the wrong direction, would someone be able to check these measurements against another camshaft gear for me....
Also, does anyone know what the idea of the spacer washer is? why would you need it?....seems that they could have machined the gear a bit shallower and you wouldn't need it....
Thanks,
Kev
Posted: Sun Feb 02, 2014 1:47 pm
by Sam Green
It stops the cam moving from end to end, the outer cover buts up to it.
Sam.