JIS Tap & Dies

Spokes · Post by **Spokes** » Sun Feb 12, 2012 7:14 pm

I just heard from a friend in Norway. He found a source for the JIS Thread Pitch tap & Dies.

http://www.TracyTools.com.

Smithers · Post by **Smithers** » Wed Feb 15, 2012 8:04 am

Looks like a good site. I was Googling the subject and found this info about the Phillips type screw heads that are JIS spec. This Instructables website is pretty neat but to really get into some neat electronic tinkering and fixing sites Ifixit.com and Ifixit.org are my favs. Anyhow just commenting on some JIS hardware.

http://www.instructables.com/id/When-a-Phillips-is-not-a-Phillips/step10/JIS-Japanese-Industrial-Standard/