Transmission
I'm ready for the bad news but still hoping that there might be an easier solution.
Split the transmission case when rebuilding the engine just to see how it looked. Mow that it is ready to hang I decided to turn the transmission. It turned fine with the kick start but when I shifted it the shaft with the sprocket on comes to a dead stop and will only make about 1/8 of a complete revolution. If I shift the other direction it also stops. I think it is shift into 2 or 3 gears, doesn't shift easily when going into the gear where it stops. Also when it does feel like it shifted ok the output shaft turns the same amount.
Thought I put it back together the way it came apart (didn't move anything) so is it easy to mess it up when putting the halves back together? If it is I'm the person to do it.
|