FourWheelForum  

Go Back   FourWheelForum > Tools, Electronics & Stereo Stuff > Restoration & Fabrication Techniques

Restoration & Fabrication Techniques Doing things right the first time.

Reply
Thread Tools
  #1  
Unread 07-04-2010, 07:15 PM
Spokes Spokes is offline
Senior Member
 
Join Date: Apr 2009
Posts: 1,575
Default Removing Wheel Bearings From The Honda CA95 or CA160 Wheel Hub

Explained below is a quick and inexpensive method of removing the wheel bearings from the Honda CA95 & CA160 wheel hubs. This method can also be used to remove wheel bearings from a blind hub on most any application.
Below for example is the front wheel from my 1968 Honda CA160.


From your local hardware store, purchase a 3/8" concrete anchor as below


Place the anchor in the bearing bore


Secure the anchor with pliers and begin to tighten the nut to expand the anchor in the bearing bore. Snug to tight. No need to overtighten.


Place a sutable drift pin or the axle through the axle bore on the other side of the hub


Lightly tap with hammer


Until the bearing is removed


Remove the axle sleeve


On the front wheel of the CA model Honda remove the speedometer drive that is mounted on the hub. For the rear wheel or models without a fixed componant in the hub, just repeat the steps above


To drive out the opposite bearing in the hub, use a suitable drift pin or homemade brass tool like mine.

Last edited by Spokes; 07-04-2010 at 07:17 PM. Reason: add info
Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -8. The time now is 09:40 AM.


Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.