|
The Honda CA95 / Benly 150 Restoration The little brother to the CA160 in our family of Hondas |
Thread Tools |
#1
|
|||
|
|||
Front Suspension Seals
Hi Everyone,
Can anyone tell me where I can source the felt seals for the leading arms? CA95,CB92 51235-200-000 FRONT FORK SUSPENSION ARM FELT SEAL CA95,CA160 51232-250-000 FRONT FORK PIVOT ARM FELT SEAL Ohio Cycles stock them but don't ship to Australia.... Or alternatively has anyone made a set from scratch? Thanks, Kev. |
#2
|
|||
|
|||
Kev, there is a complete front end recon kit in Malaysia, see how it compares with buying from the States and having a member post it on to you.
http://www.ebay.co.uk/itm/NOS-Honda-...item3f231f559c Sam. |
#3
|
|||
|
|||
I make them from scratch everytime I need to.
Buy some felt cloth. Imprint the part into the felt. Trace & cut with whatever sharp tool you have. Or cut a thin strip long enough to make the circle you need. |
#4
|
|||
|
|||
You're up early Chip.
|
#5
|
|||
|
|||
Yes...and off to the plant.
|
#6
|
|||
|
|||
Thanks for the replies Gents.
I bid on the complete kit in Malaysia but was out done...I already have the bushes and my bolts have minimal wear so i was only after the felt seals anyway. I'm keen to make my own. Spokes - Just wondering if the felt cloth needs to be super tough, or would the standard type you can get from a craft shop be enough? Kev. |
#7
|
|||
|
|||
Craft quality felt works very well.
|
#8
|
|||
|
|||
Ta Muchly
|