View Single Post
  #15  
Unread 08-17-2013, 03:09 PM
Larzfromarz's Avatar
Larzfromarz Larzfromarz is offline
Senior Member
 
Join Date: Dec 2011
Posts: 620
Default

Jumping in here- I'd suggest a large brass drift after the obligatory soaking in (insert here).
Very likely the inner bearing race is seized to the shaft (duh). Expect to replace the bearings, over the counter sealed unit work the charm. Driving in the direction of the brake hub should at least get the assembly out of the wheel hub.
Since the hubs are cast be careful around any edges where they would tend to be weaker.
Reply With Quote