View Single Post
  #20  
Unread 09-23-2011, 11:23 AM
montanaman montanaman is offline
Member
 
Join Date: Sep 2011
Posts: 53
Default

Well I measured everything and suprisingly everything was with limits. The cylinder is not that bad at all either. So i guess I could go the cheap route and just get some new rings, or get a ,25 mm over piston and have it honed. I want to go the easy route, but I'm sure I will regret it. Here is a couple pictures of the cylinder.
Attached Images
File Type: jpg IMAG0135.jpg (56.3 KB, 5 views)
File Type: jpg IMAG0134.jpg (57.1 KB, 5 views)
Reply With Quote