Thread
:
PIAA Light Repair - 1st Gen
View Single Post
#
5
02-19-2011, 11:05 PM
Smithers
Admin
Join Date: Feb 2004
Location: San Luis Obispo, CA
Posts: 3,238
I didn't realize I would be able to fix it for quite some time so I didn't take pictures while I was playing with all the different pieces I had to experiment with. I finally found a small wire coupler that I could roll tight in order to make clamp onto the small bulb prongs and then would work well enough. I assembled everything as best as I could then mixed up some JB Weld that I applied to hold everything into place. Once that stuff hardens there is no going back and this was the last time I was going to fix these lights. If it breaks again or burns out this light is going into the trash.
Last edited by Smithers; 02-20-2011 at
09:38 AM
.
Smithers
View Public Profile
Visit Smithers's homepage!
Find all posts by Smithers