View Single Post
  #5  
Unread 03-06-2013, 11:48 PM
Smithers's Avatar
Smithers Smithers is offline
Admin
 
Join Date: Feb 2004
Location: San Luis Obispo, CA
Posts: 3,238
Send a message via AIM to Smithers Send a message via Skype™ to Smithers
Default

Ah that sounds like a time saver. Anything with multiple cylinders sure calls for some tools to speed things up that's for sure. It's no big deal to swap out shims. You just have to request shim donations from anyone on a forum that's willing. Lots of people have shim kits that hardly use any of them. It just a matter of time of course.

Here is a pic of a prep bench at my machinist's shop. The RMZ head sitting next to the Honda Prelude cylinder head that I had machined at the same time.



Meanwhile back at the garage... not much going on until the head comes back.


Last edited by Smithers; 03-07-2013 at 12:13 AM.
Reply With Quote