View Single Post
  #38  
Unread 02-22-2009, 09:09 PM
Smithers's Avatar
Smithers Smithers is offline
Admin
 
Join Date: Feb 2004
Location: San Luis Obispo, CA
Posts: 3,238
Send a message via AIM to Smithers Send a message via Skype™ to Smithers
Default

The engine will sit down a little more but I took this picture to look at while I think of a good design for the engine mounts.



Underside shot of the driver's side. Headers clear the steering shaft slightly but there is a collar that will hit it when it turns. No biggy. I'll just cut off the flange and redirect it to go in the right direction towards the middle of the under chassis where it should be going.

Reply With Quote