View Single Post
  #9  
Unread 12-02-2008, 12:18 AM
Smithers's Avatar
Smithers Smithers is offline
Admin
 
Join Date: Feb 2004
Location: San Luis Obispo, CA
Posts: 3,238
Send a message via AIM to Smithers Send a message via Skype™ to Smithers
Default

A cordless Dremel would be idea here with a steel brush cup bit to clean up some of the deep grooves inside the carb. Unfortunately mine is worthless because the battery just gave up after a couple hours of use.. what a POS. Anyhow this is getting ready to replace the float and needle after the dip. If I worked any harder at removing anymore residue I would probably damage something or wear out the details in the casting. This is nice and adequate.

Reply With Quote