View Single Post
  #12  
Unread 02-09-2011, 09:33 PM
Smithers's Avatar
Smithers Smithers is offline
Admin
 
Join Date: Feb 2004
Location: San Luis Obispo, CA
Posts: 3,238
Send a message via AIM to Smithers Send a message via Skype™ to Smithers
Default

And don't forget the floor that I chopped out. I grabbed some thing steel from another friends shop and welded it in nice and flat. I just roughly cut it out with the plasma cutter and then tacked it on and hammered it down. When you get it close you just hammer the metal to close up the gaps and keep welding. It went faster than I thought but I'm also getting pretty good welding thing metal too.



So I bent the new piece of steel and made an educated guess where the cross bars would be located and but a couple strips out of it for that.


Reply With Quote