View Single Post
  #3  
Unread 01-06-2012, 06:34 PM
daxsonvt daxsonvt is offline
Junior Member
 
Join Date: Apr 2011
Posts: 20
Default

Thanks for the info.

I started at it with a 3m pad I had laying around and it seemed to work, though slowly. I had my dremel tool out for some other work and in the box of attachments I found these things.

They had the same feel and consistency of the 3M pad so I decided to give it a go on a less important piece that could be replaced for less than the head. I only used the finer grit and it worked great. The wheel did wear kinda quick, but I was putting a fair amount of pressure on it to get it into some corners. Avoiding sharp corners, keeping the speed down, and keeping the pressure down and they should last long enough to finish everything.

I'll have pictures of everything and a longer description on my blog in the next few days.
Reply With Quote