View Single Post
Unread 06-13-2012, 11:19 PM
Smithers's Avatar
Smithers Smithers is offline
Join Date: Feb 2004
Location: San Luis Obispo, CA
Posts: 3,237
Send a message via AIM to Smithers Send a message via Skype™ to Smithers

Ok the first big problem here is the quality of the wiring. The o2 sensor wires were damaged and needed repair. This is what happened and it's wrong. I pulled up the correct wiring diagram and got started. I just had to cut 4 of the wires on the connector and reconnect them.

Not good!

I pulled out the soldering station and got to work. Some heat shrink, flux and fresh stripped copper wire makes everything nice and clean.

Reply With Quote