FourWheelForum

FourWheelForum (http://www.fourwheelforum.com/index.php)
-   Restoration & Fabrication Techniques (http://www.fourwheelforum.com/forumdisplay.php?f=29)
-   -   Removing Wheel Bearings From The Honda CA95 or CA160 Wheel Hub (http://www.fourwheelforum.com/showthread.php?t=1029)

Spokes 07-04-2010 07:15 PM

Removing Wheel Bearings From The Honda CA95 or CA160 Wheel Hub
 
Explained below is a quick and inexpensive method of removing the wheel bearings from the Honda CA95 & CA160 wheel hubs. This method can also be used to remove wheel bearings from a blind hub on most any application.
Below for example is the front wheel from my 1968 Honda CA160.
http://www.fourwheelforum.com/pictur...&pictureid=221

From your local hardware store, purchase a 3/8" concrete anchor as below
http://www.fourwheelforum.com/pictur...&pictureid=222

Place the anchor in the bearing bore
http://www.fourwheelforum.com/pictur...&pictureid=223

Secure the anchor with pliers and begin to tighten the nut to expand the anchor in the bearing bore. Snug to tight. No need to overtighten.
http://www.fourwheelforum.com/pictur...&pictureid=224

Place a sutable drift pin or the axle through the axle bore on the other side of the hub
http://www.fourwheelforum.com/pictur...&pictureid=226

Lightly tap with hammer
http://www.fourwheelforum.com/pictur...&pictureid=227

Until the bearing is removed
http://www.fourwheelforum.com/pictur...&pictureid=229

Remove the axle sleeve
http://www.fourwheelforum.com/pictur...&pictureid=230

On the front wheel of the CA model Honda remove the speedometer drive that is mounted on the hub. For the rear wheel or models without a fixed componant in the hub, just repeat the steps above
http://www.fourwheelforum.com/pictur...&pictureid=232

To drive out the opposite bearing in the hub, use a suitable drift pin or homemade brass tool like mine.
http://www.fourwheelforum.com/pictur...&pictureid=231


All times are GMT -8. The time now is 07:00 AM.

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.